Troubleshooting a Shaker Dust Collector

Do bags shake when shaker operates? Yes / No

Are bags tensioned properly? Yes / No

Does isolation damper close or id fan stop during shaking? Yes / No

Is shaker cleaning interval at the shortest interval between compartments? Yes / No

Does the shaker operate at 30 seconds maximum? Yes / No

Check pins, keys, bearings, etc. Repair

Retention and check differential pressure.

Repair isolation damper or stop fan. Check differential pressure.

Shorten interval and check differential pressure.

Set cycle to 20-30 seconds

Did you pull a filter bag and run a permeability test to check for blinding? Yes

Is filter bag blinding? Yes / No

Analyze for cause of blinding and correct; Replace filters and check differential pressure.

Is air/cloth ratio less than 6:1 if pulse-jet, 4:1 if Plenum Pulse, or 3:1 if reverse air or shaker? Yes / No

Is material being continuously removed from hopper? Yes / No

Contact BPS for further recommendations.

If pulse-jet or plenum pulse, consider pleated media conversion. If reverse air or shaker, consider pulse-jet conversion or increasing collector size.

Remove material continuously and check differential pressure.

Top Of Page